Product DescriptionPRODUCT FEATURES:Anti-reflective layer;Hard coated layer;Silicon adhesive layer.
psp screen protector (Rating: 3 out of 5) good quality for the price, although they could have made it slightly bigger for the psp slim. make sure when applying that you get it dead center by not starting exactly from the edge as you will notice a gap on the other side if you do. in other words, as you line it up using either the left or right side edge of the screen, give yourself about a millimeter from the edge and you should be dead center with another millimeter gap on the other side.
Take your time!!! (Rating: 5 out of 5) I was really excited when I got the filter. I rip off the max for the filter and slap the filter on the psp screen. I was disappoint. There was massive amount of air bubble on the screen. Then I remember people talking about the credit card trick to which you take the card and slowly scrape the air bubble out. That did not work... I went on youtube and found out that you have to slow place the filter down while slowly scraping the filter at the time. Learn from my mistake.
1. Clean the psp as clean as you can.
2. Have a credit card or any type of card on hand.
3. READ I repeat READ which mask to take off. For some reason this will make less air bubble.
4. slowly and easily match the corner of the filter to the psp screen and lay it down while using the card to scrape out any air bubble.
5. Take off the top layer of the filter's mask.
6. Enjoy your psp. XD
Gr8 Stuff (Rating: 5 out of 5) The protective filter fitted like a glove, it gives a draker depth to the PSP screen which is really good.
Just get it!!
Only one filter!!! (Rating: 2 out of 5) I thought the pack would include 5 filters or at least 2. Only one with this price!
You get but one chance to put it on correctly... (Rating: 3 out of 5) This is an excellent product when applied correctly. My complaint is that you only get one filter. For $6.00 you'd think there would be at least two in the package...it can't cost more than a few pennies to manufacture one of these. I did get mine applied correctly the first try...well almost.
I used the soapy water solution that one of the other reviewers suggested. This helped a lot and made it easy to position it correctly on the screen. Once all the liquid was pushed out from under the protector film, I could barely tell the film was there. It fit the screen of my brand new PSP slim very well. The problem is that there was a small bubble on the edge that really bothered me (I'm a perfectionist). When I lifted up the edge of the film to remove the speck of dust causing the bubble...it all when to hell!
Once you expose the sticky surface, EVERYTHING sticks to it. Every single speck of dust that sticks to it causes a tiny bubble. As I pulled it up to fix the tiny bubble, it caused two more...as I lifted up to fix those bubbles, it got worse. If only I had a second try of it, I know I could do it...but I don't feel like spending another $6.00 for it.
One other very important note. The volume buttons on my new PSP stopped working about two hours later. I may have gotten some of the moisture inside of the unit. Either that or the unit was already defective...I don't know. Luckily, Amazon sent me a replacement PSP right away (thank you, Amazon!).